ATV – Page 9 – SafetyAtWorkBlog

WorkSafe enters battle over quadbike safety

A decision by WorkSafe Victoria about the fitting of crush protection devices (CPD) to quad-bikes (All Terrain Vehicles/ATV) gained the major prominence in the latest edition of a major Australian farming newspaper, The Weekly Times. The newspaper reports that

“WorkSafe Victoria is tightening rules around quad bikes that will see them banned in workplaces unless appropriate rollover protection is fitted.”

Some of the argument over the last 24 hours has been around whether this means that CPDs are mandatory and, as always, cost.

Subscribe to SafetyAtWorkBlog to continue reading.
Subscribe Help

Already a member? Log in here

Stats show quadbikes remain the leading cause of deaths on Australian farms

Dr Tony Lower, Director of the Australian Centre for Agricultural Health and Safety has released his review of farm safety incident statistics for 2015. According to a media release (not yet online), Dr Lower found

“…there were 69 on‐farm injury deaths. The main causes continued to be quads, accounting for 15 cases (22%), with two of these involving children. This is the fifth year in a row where quads have been the leading cause of non‐intentional injury deaths on Australian farms.” Continue reading “Stats show quadbikes remain the leading cause of deaths on Australian farms”

A possible change in approach on quad bike safety

The Federal Chamber of Automotive Industries (FCAI) is an integral stakeholder in the improvement in the safety performance of quad bikes. However, some of its past strategies have been belligerent, divisive and have limited the safety debate. There are hints that the FCAI’s communication strategy has changed and this can only be for the better.

On October 1, 2015, FCAI issued a media release that was a gentle questioning of the Star Safety Rating program recently advocated by quad bike safety advocates and researchers. The FCAI says that the research on which the rating system is based

“…does not correlate with real world performance is premature and needs to be further explored.”

Continue reading “A possible change in approach on quad bike safety”

Quad bike safety discussion is maturing

New research into quad bike safety by the University of New South Wales (UNSW) shows increasing maturity in the discussions on the safety of quad bikes and farms. According to a 2 September report on Australian ABC radio, more attention is now needed for quadbike rider’s actions, workplace conditions and choices.

The attention on the suitability and design of quad bikes has dominated the safety debate over the last few years. There is no doubt that the design of quadbikes could have been made safer, or that new vehicle models offer better stability or that Operator Protection Devices (OPDs) offer a safety improvement.

The focus on riders has been almost exclusively about “active riding” techniques and the use and suitability of personal protective equipment, such as helmets. Continue reading “Quad bike safety discussion is maturing”

Coronial findings and research – another step on the rocky road

The final report into quadbike safety has finally been released by the University of New South Wales in a series of five papers and in the wake of Queensland coronial findings into nine quadbike-related deaths. (A New South Wales inquiry is currently underway)

It has been a

Subscribe to SafetyAtWorkBlog to continue reading.
Subscribe Help

Already a member? Log in here

New research lays down the challenge on quad bike safety

In June 2015 a research report was presented to a traffic safety conference in Gothenburg, Sweden that is set to reignite the debate on quad bike or all terrain vehicle (ATV) safety in Australia.

The paper entitled “The Australian Terrain Vehicle Assessment Program (ATVAP)” (Paper No.15-0144-W in the Technical Papers section of the

Subscribe to SafetyAtWorkBlog to continue reading.
Subscribe Help

Already a member? Log in here

The safety features of the new Polaris set a new benchmark

The Weekly Times scored an exclusive this week about a new model of Polaris quad bike which incorporates a roll cage or rollover protection structure (ROPS) in its design. The significance of the Sportsman Ace is, according to the newspaper and the manufacturer, a “game changer” because it seems to counter the arguments of the quad bike manufacturers against such design changes in submissions to government and in public campaigns. They have stressed that more effective control of a quad bike comes from driver training and behaviour and that ROPs may itself contribute to driver injuries and deaths. The Polaris Sportsman Ace, to be released in the United States this week and Australia next month, seems to prove that quad bikes can be redesigned to include safety features, an action that manufacturers have been extremely reluctant to do.

A major critic of ROPs on quad bikes in Australia has been the Federal Chamber of Automotive Industries (FCAI). SafetyAtWorkBlog spoke to a spokesman for the FCAI who explained that the Polaris Sportsman Ace is not an All-Terrain Vehicle (ATV) but a UTV (Utility Terrain Vehicle). Continue reading “The safety features of the new Polaris set a new benchmark”

Category: ATV

WorkSafe enters battle over quadbike safety

Like this:

Stats show quadbikes remain the leading cause of deaths on Australian farms

Like this:

A possible change in approach on quad bike safety

Like this:

Quad bike safety discussion is maturing

Like this:

Coronial findings and research – another step on the rocky road

Like this:

New research lays down the challenge on quad bike safety

Like this:

The safety features of the new Polaris set a new benchmark

Like this:

Share this:

Like this:

Share this:

Like this:

Share this:

Like this:

Share this:

Like this:

Share this:

Like this:

Share this:

Like this:

Share this:

Like this: