Pressure is increasing on the manufacturers of quad bikes in Australia and from a variety of sources. The Weekly Times newspaper continues, almost fortnightly, to report on the safety debate about the use and design of quad bikes. The 9 June edition has a double-page spread on the issue with many direct quotes from “players” … Continue reading “Quad bike manufacturers resist the inevitable”
SafetyAtWorkBlog was able to contact the Federal Chamber of Automotive Industries’ Rhys Griffiths this afternoon seeking clarification of the FCAI’s withdrawal from quad bike safety discussions reported yesterday. Prior to withdrawing, a document was read to the quad bike safety working group. The document has not been released publicly but below is the gist. Further … Continue reading “Source data from within the quad bike safety stoush”
In early 2010, Australia’s Heads of Workplace Safety Authorities (HWSA) established a trans-Tasman working party to look at the safety issues of quad bikes, often called all-terrain vehicles. The working group is in the final stages of its report and a major motorcycle industry representative has not liked the findings and has apparently withdrawn from the working group. A report on … Continue reading “Quad bike manufacturers walk out of safety working group”
Last week, Honda quad bike dealers were supplied with the safety code provided by the Federated Chamber of Automotive Industries. This code outlines research that shows some roll over protection (ROPS) devices may increase the risk of injury. A major ROPS identified in recent reports is the QuadBar, a device that may be “set to … Continue reading “Industry action confuses quad bike sellers”
A week on from Australia’s The Weekly Times using its front page to open a debate about roll over protection structures (ROPS), the debate has continued in the letters and op-ed pages of The Weekly Times. Dr Yossi Berger of the Australian Workers Union asks the valid question in his opinion piece – should all … Continue reading “People enter the quad bike ROPS debate”
A major Australian rural newspaper, The Weekly Times, has devoted its front page to an article on rollover protective devices on quad bikes. It has taken as the base new information released by the Australian Centre for Agricultural Health and Safety (ACAHS) through a media release. The new policy paper and the supporting Practical Management Guide … Continue reading “New quad bike research and practical safety guidance”
SafetyAtWorkBlog has been following the discussions about safety of all-terrain vehicles and quad bikes for some time. This is because the use of these vehicles encapsulate so many of the issues that workplace safety needs to deal with: Safe design Personal protective equipment Hierarchy of controls The line between private activity and work activity Personal responsibility The “nanny … Continue reading “Quad bike safety issues continue with no end in sight”