Category: WorkSafe

Quad bike manufacturers resist the inevitable

Pressure is increasing on the manufacturers of quad bikes in Australia and from a variety of sources.

The Weekly Times newspaper continues, almost fortnightly, to report on the safety debate about the use and design of quad bikes.  The 9 June edition has a double-page spread on the issue with many direct quotes from “players” in the debate.  The fact that a national rural newspaper has devoted this level of column inches is indicative of the controversy.  The Australian metropolitan dailies have not followed this lead but, as we have seen in previous blog posts, major New Zealand papers have covered the issues.

Some Australian government departments are applying the cautionary principle under legislative occupational health and safety (OHS) obligation and have restricted the use of quad bikes pending risk assessments.  SafetyAtWorkBlog has heard that one department, New South Wales’ National Parks & Wildlife Service, has passed through the assessment phase  and will be fitting Crush Protection Devices (CPDs) to their quad bikes by the end of August 2011.

A source close to the debate has told SafetyAtWorkBlog that

  • There is an increased likelihood for coroners’ inquests in a number of states;
  • The quad bike industry has begun formally misrepresenting the value of CPDs in posters, of which several have been provided to quad bike distributors; and
  • The industry continue to assert that research shows CPDs cause more harm than good but provide no evidence of this. Continue reading “Quad bike manufacturers resist the inevitable”

Will Brodie’s Law deter workplace bullying?

On 1 June 2011 the Australian television program 7PM Project ran an article about “Brodie’s Law” – an increase in the penalties for bullying and stalking.  I was approached to be interviewed for the program due to my comments on this blog.  I turned down the opportunity for a number of reasons, my time had already been committed to my family and filming did not fit that commitment but, more importantly, I am dubious about whether Brodie’s Law will have the deterrent effect that many hope for.

The 7PM Project approached an outspoken lawyer on the issue who refused to participate because he felt that his comments would not have fitted the approach favoured by the producer who contacted us.  I had similar reservations.  When I expressed my opinion about the lack of deterence, one producer acknowledged that this was a position expressed by almost all the people they had approached to participate.

The video of the 7PM Project segment is available online and begins around the 2 minute mark.  Significantly occupational health and safety laws were not mentioned in the article.  There was no mention of any of the OHS guidances on workplace bullying or of any of the regulator’s programs.

A workplace bullying expert of OHS professional would more likely have recited this definition or at least stressed the importance of repetition.

The speaker they chose for expert opinion on workplace bullying was Grant Brecht.  Brecht was asked whether a definition of bullying exists.  He answered that the definition relates to where psychological harm is possible.  This is true but a crucial element of the definition of workplace bullying  was missed in the discussion.  According to WorkSafe Victoria:

“Bullying is repeated unreasonable behaviour directed towards a worker or group of workers that creates a risk to health and safety.” [emphasis added]

Brecht also mentioned the need for individuals to assert themselves in the face of bullying but a detailed look at Brodie Panlock’s case shows that she did assert herself and that she did approach other workers at the cafe for assistance and she did talk to friends about the situation. That none of these actions helped Brodie is a core element of her tragedy.  Bullying, as with many workplace hazards, is best dealt with by not allowing it to take root in any workplace from the very beginning of a business’ operation.  Too many try to retrofit safety into an already toxic and dysfunctional workplace.

The 7PM Project also ran some dubious re-enactments of workplace bullying and, incongruously, some footage of a construction site?! Continue reading “Will Brodie’s Law deter workplace bullying?”

New OHS info on Working Alone and Occupational Violence

One of the most difficult safety management challenges is the control of hazards associated with working alone.  The most effective control is to not work alone, but the difficulty comes because this option requires expenditure.

WorkSafe Victoria recently released an information sheet on this hazard and listed the following hazard control options:

  • Buddy system
  • Environmental design
  • Communication or location systems
  • Alarms
  • Movement records
  • Training
  • Knowledge sharing

WorkSafe wisely says that most workplaces will require a combination of these options to control the hazard of working alone.

Trying to reduce the hazards of working alone is a terrific indication of the economic health of a business, the level of safety commitment of a business owner or manager, and the state of safety knowledge in the company. Continue reading “New OHS info on Working Alone and Occupational Violence”

Quad bike manufacturers walk out of safety working group

In early 2010, Australia’s Heads of Workplace Safety Authorities (HWSA) established a trans-Tasman working party to look at the safety issues of quad bikes, often called all-terrain vehicles.  The working group is in the final stages of its report and a major motorcycle industry representative has not liked the findings and has apparently withdrawn from the working group.  A report on the increasing tensions was published in  this week’s The Weekly Times.  SafetyAtWorkBlog has been told that the quad bike industry representative has walked out in protest.

Let’s look at what HWSA said about the working group in May 2010:

“HWSA Chair, John Watson, said every farming fatality leads to immeasurable suffering in close-knit rural communities and these figures are not acceptable.
“The working group is expected to deliver solutions to safety problems associated with use of quad bikes on farm properties and raise awareness of practical risk controls,…
“The group will look at issues that include design, safety equipment, training and instruction, aftermarket accessories, safe use and point of sale,….
“The joint program of work will be delivered through an Industry Solutions Program where industry and regulators work together to address high risk safety issues – an initiative that has successfully provided practical solutions to a number of issues across many industries.
“The working group is focused on producing tangible and sustainable safety outcomes across the farming and agricultural industry where quad bikes are commonly used….”
Of significance in that media release is that Chief Executive of the Federal Chamber of Automotive Industries (FCAI) Andrew McKellar said

“It is our objective that all quad bike users are well informed of the manufacturer’s recommendations in relation to the safe use of these vehicles…”

The sticking point in the working group was, according to The Weekly Times, that

“”…the committee was expected to back the recommendation to “consider fitting an anti-crush device”, the strongest position yet for roll-over protection.”

The committee did recommend this and apparently the FCAI walked.  Attempts have been made to contact the FCAI to confirm their action and their objections. Continue reading “Quad bike manufacturers walk out of safety working group”

Forklift incidents continue

One of the the most hazardous pieces of equipment in modern workplaces is the forklift.  Sadly it is also one of the most useful.  A recent prosecution in Western Australia provides an example of many of the serious risks in using forklifts:

  • untrained or undertrained drivers
  • unsafe decisions by employers
  • the safety role of seatbelts
  • labour hire management and staff supervision
  • driving with forks elevated
  • training certification.

Other related issues are the employment of

  • transient labour, and
  • young workers.

According to a WorkSafe WA media release, the basic facts of the incident are

“Flexi Staff supplied two casual labourers to the Beds Plus warehouse in Kewdale in February, 2008. The two men were British citizens on a working holiday in Australia. [links added]

It was not part of their labouring job to operate forklifts, and neither had any experience or qualifications or High Risk Work licences. Continue reading “Forklift incidents continue”

OHS compliance checklists

For several months some Australian OHS regulators have been providing “Compliance at a glance” checklists. These are not intended to establish compliance, particularly in the small business sector as listed on one regulator’s website , but are more brief indicators of areas for greater improvement.

Nevertheless the items listed in the “red zone” of the checklists establish a benchmark of NON-compliance. These items are listed below:

Farm deaths require radical approach

WorkSafe Victoria has reported  that of seven recent work-related fatalities, three have occurred in regional areas on farms.  The most recent death was misreported as involving a quad bike.

In a media release issued on 10 May 2011, WorkSafe’s Ian Forsythe said,

“Safety’s not just about what WorkSafe does. It’s about employers, workers and the wider community taking ownership of it not just for themselves, but the wider community.

It is imperative that regional Victorians, whether they are employers, self-employed or workers to stop and think about what is ultimately important to them and what they can do to prevent more tragedies affecting them and their communities.”

Over the last 20 years WorkSafe has tried a wide variety of safety campaigns in rural farming communities.  Some have Continue reading “Farm deaths require radical approach”

© Workplace Safety Services P/L (ABN: 68091088621) and SafetyAtWorkBlog, 2008-2024. Unauthorized use and/or duplication of this material without express and written permission from this blog’s author and/or owner is strictly prohibited. Excerpts and links may be used, provided that full and clear credit is given to Kevin Jones and SafetyAtWorkBlog with appropriate and specific direction to the original content.

Concatenate Web Development
© Designed and developed by Concatenate Aust Pty Ltd